adioboy

Hi. I have surround sound speakers for my home. Only problem is i have speaker wire comming out my ears! Is there any way i could make something be RF.

i figure the wire carries information. so why can't it be broadcast over a channel of X Hz, then the 2nd speaker could be X+1 Hz...actually i have no idea.

any help is nice

SinisterMotives

The wireless setup you want would require placing a separate single-channel amplifier in addition to an RF receiver near each speaker. The wire not only carries a signal, it provides the current from the amplifier necessary to move the speaker cones.

adioboy

i'd need a seperate amp and batteries for each speaker...hmmmm

DelayedReaction

Why not run the speaker wires through the walls? The sound quality will be FAR better than RF, and you'll have a much cleaner look. They also make molding which can be used to disguise wires; check around at your local hardware store.

__________________
If ignorance is bliss, you must be having an orgasm.

SinisterMotives

You could also run the wires under the carpet.

Cycler

Up throught the attic and down to the speakers. Really cleans it up.

__________________
"I'm not even supposed to be here today."

"I assure you we're open."